K&D Factory Service Inc. has been bringing OEM commercial cooking parts and service to restaurants and commercial kitchens of Ronks, PA and the surrounding areas since 1945!
Read our reviews and find out why your colleagues consider us to be their nearby commercial cooking supply company in Ronks, PA.
for Ronks, PA
Our Reviews by City
Arrived on, 7/10/23 - Mike A - Arrived on site and inspected unit. Bottom unit control panel high limit is tripping intermittently. Reset and have proper functions. Unit not over temping. Exhaust fan running but getting hot. Will obtain replacement fan and high limit. Unit ok for use but may still trip with having a weak high limit and fan overheating. Returned on, 7/13/23 - Mike A - Arrived on site and installed replacement cooling fan and internal high limit. Tested unit and have proper functions. Also used foil tape to insulate seams of exhaust stack. Unit ok for use
Commercial Kitchen Appliance Repair Service. Arrived at the client's location on 5/30/23 to repair their commercial oven. Bottom oven not turning on. Verified power into unit. Tested fuses and found to be good. Temp high limit not tripped. Found internal control box high limit tripped. Inspected fan is operational and no air obstructions. Reset high limit and ran unit to verify high limit not tripping. Let unit heat to ready and continued to monitor and continue to have proper functions. Unit ok for use. If high limit trips again suspect weak high limit.
Arrived at location on 3/3/23 - Installed replacement valve and linkage hose for top unit. On removal of U bolts that mount valve had heavy corrosion and broke. Sourced replacement U bolts locally. Tested unit and have proper functions and no leaks. Unit ok for use
Arrived at location on 5/12/13 with follow up parts for flat top grill. Pulled unit out, turned gas off, removed covers and replaced thermostat valve. Lit all pilots, tested unit has and all zones working well with good temperatures.
12/22/2020 - arrived, stated IMP Oven unit was still not heating properly. having it set to 325 it was only heating to 200 or less. checked unit over, turned on and allow to heat, unit did heat to set-point of 350 fine. allowed to cool and heat back up. cycled several times. operating. removed covers, checked components, tapped on ignition module and flame cut in and out every time. bad ignition module. will order and return. 12/31/2020 - did replace the ignition module. taped on to make sure it stays on. checked oven temperature. all ok and ready to use
Replaced 2 gas valves with customer supplied valves and cleaned out the burners. I checked ops. okay, ready to use. no model or serial number tag. unit is a CPG CHAR GRILL