K&D Factory Service Inc. has serviced commercial refrigeration & commercial kitchen equipment in Elizabethtown PA since 1945.

Call us now at: 1-800-932-0503 or check out why commercial kitchens turn to K&D Factory Services for our top-rated commercial cooking equipment, parts and repair needs in Elizabethtown PA.

Local Reviews
for Elizabethtown, PA

K&D Factory Service Inc. Rated 5.0 out of 5 stars based on 1 customer reviews


Hardlines Manager




Review of K&D Factory Service Inc.


Service C.

Service C.

Found bottom left combi has a leak in the steam generator and the spark is weak causing delayed ignition and popping sound. I will obtain parts and return. Steve said to repair it. I will obtain parts and return. 3/6/20 Did replace the steam generator assembly and burner and module and drain hose. I set co to 9.4% at 71 rpm. I checked ops. OK ready to use.

Near Sheaffer Rd, Elizabethtown, PA 17022
Service C.

Service C.

stated Oven unit displaying F1 error, went into test mode, run blower motor, does not run, remove covers, spin motor by hand, is rough, motor now does turn on through test mode but is very loud. blower motor going out. will order and return. 5/29/19 removed covers from unit, removed old blower motor from unit. install new. reassemble covers onto unit. plug in, turn on, allow to heat, blower now running quietly. check amp draw on heaters and mag circuits. OK on heating circuits. test make product. OK for use.

Near N Market St, Elizabethtown, PA 17022
Service C.

Service C.

Installed customer supplied temperature controller for Conveyor Oven. I did match the perimeters with the other control. checked ops. Okay, ready to use. control came from northern pizza equipment 1 800 426 0323 MPI TEMPERATURE CONTROL

Near S Market St, Elizabethtown, PA 17022
Service C.

Service C.

Conveyor Oven, bottom temperature controller not working, called factory, Joe will call me back - he is trying to find a replacement controller.

Near S Market St, Elizabethtown, PA 17022
Service C.

Service C.

Found Combi-Oven steam hose loose on the back of the steamer. I did secure the steam hose back on the steamer. I did replace a leaking water supply hose. Door gasket is cracked, needs replaced. I checked ops, ran a clean cycle, checked, all heat elements are working, will get new door gasket and return. 3/21/19 Installed a new door gasket. I cleaned glass sealing surface and cleaned up the drip tray. I checked ops. okay, ready to use.

Near Masonic Dr, Elizabethtown, PA 17022
Service C.

Service C.

Commercial kitchen equipment maintenance. Found Combi Oven error indicator light on, found the grease filter installed incorrectly. I did reinstall filters and checked ops, okay, ready to use. Found door gasket is very poor condition. Will obtain parts and return 10/30/2018--part ided 11/05/2018 Did replace the door gasket, I checked ops, okay, ready to use

Near Masonic Dr, Elizabethtown, PA 17022
Service C.

Service C.

Found motor pick up, speed sensor broken on Conveyor Oven, will obtain parts and return 8-27-18 Arrived, unplugged oven, replaced motor speed sensor. reassembled and plugged back in. turned on, conveyor turns without issues. allow to heat up. okay for use. Also bent ends of master links on chain so they were not sticking up and catching.

Near S Market St, Elizabethtown, PA 17022
Service C.

Service C.

Found Combi Oven unit displaying error 40. Checked and found care pump not running fast enough and causing tray to overflow with water. Replaced care pump and test run. Runs good. Advised customer to run through clean cycle at end of day, then error will no longer show up. Unit is okay for use.

Near Masonic Dr, Elizabethtown, PA 17022
Service C.

Service C.

Found temperature controller bad on Convection Oven. I did replace the controller and checked ops. Okay, ready to use

Near N Market St, Elizabethtown, PA 17022
Service C.

Service C.

Found one contactor coil is bad. Checked voltage to the coil. All OK at 211 volts. Found no ground fault. Checked amp draw on the good coil. Reads .034 amps. Will obtain new contactor and return.*120 volts per leg to ground. 210 across the coil. No sign of any moisture or leaking at contactors. 2-27-2017 Did replace the bad contactor. I checked operation found contactors are getting hot from heat produced from kettle. Coil outside temperature reached 143 deg. in open air. Will contact factory to advise. Also unit lost it's vacuum. Will need safety and bleeder valve. 4-3-2017 Returned, installed contactor upgrade bracket. Mounted contactors. I replaced the pop off valve and the vent. I pulled a vacuum on the kettle. Checked operation. Unit boils. All OK and ready to use.

Near Ridgeview Rd S, Elizabethtown, PA 17022
Service C.

Service C.

Found infinite switches bad. I did replace the switches and knobs. Decals need replaced if possible. Will obtain decal pack and return. * No decals available for unit.

Near N Market St, Elizabethtown, PA 17022
Service C.

Service C.

Found contactor coils are bad on both contactors. Checked heat element OK. Will obtain parts and return. 1-20-2017 Returned and replaced the heat contactors. Checked operation. Unit draws 68 amps per leg. All OK. Pulled a vacuum on the kettle and checked temperature and pressure and boiled water. All OK and ready to use.

Near Ridgeview Rd S, Elizabethtown, PA 17022
Service C.

Service C.

Spoke to customer. He said unit trips the breaker when they put water in the pan to steam. Did check the pan for leaks. Found none. Did find caulking thin around the pan and could see where moisture was getting into the wire way. Did re-caulk around the pan and checked operation. Taped temperature bulb to the pan and replaced missing hardware. Good moisture coming from pan. Unit is getting hot and is ready to use. *Always fill water tray then install into unit. Don't fill water tray while it is in the unit.

Near Merts Dr, Elizabethtown, PA 17022
Service C.

Service C.

Checked and found pump leaking when ran. Spoke to Jeff at factory to ID part. Dennis would like parts ordered QWP. (expedited freight) Removed motor. Removed pump. Found very bad corrosion on pump housing. Used wire wheel to clean. Replaced gasket and seals. Reassembled unit. Tested. Found unit leaked around outside housing now. Removed again. Applied sealant to gasket. Tested. No more leaks. OK for use.

Near Elizabethtown, PA 17022
Service Check-In ..

Service Check-In ..

RATIONAL ELECT OVEN Tech - Replaced hose reel assembly and tested.

Near Masonic Dr, Elizabethtown, PA 17022
Service Check-In ..

Service Check-In ..

Rational Electric Oven Tech - Found both fan motors are bad. Top unit cooling fan is broken. Bottom unit doesn't show RPMS when running. Found water valves are bad. Low water volume thru the valves. Customer not fixing, is going to replace.

Near Masonic Dr, Elizabethtown, PA 17022
Service Check-In ..

Service Check-In ..

Norlake Walk In-Cooler Tech - Performed startup. Pulling 6 AMPs pressure 240/18 placed into defrost heaters

Near Elizabethtown, PA 17022