Careers Call Now Contact Us

Lock Haven PA Commercial Refrigeration

K&D Factory Service has been providing factory authorized kitchen equipment parts and service to the businesses of Lock Haven, PA and the surrounding areas since 1945!

Read our reviews and find out why your colleagues call us when they need OEM parts and equipment or refrigeration repair services in Lock Haven, PA.

Local Reviews
for Lock Haven, PA

K&D Factory Service Inc. Rated 5.0 out of 5 stars based on 2 customer reviews
Mobile Tools for Contractors and Service Professionals Powered by Nearby Now


Map of Lock Haven, PA

good service and responce time




Review of K&D Factory Service Inc.


Map of Lock Haven, PA

good job, great service.




Review of K&D Factory Service Inc.


Service C.

Service C.

Found CLE Steamer unit on, turned off let drain, turned on to fill found to fill slow and once both compartments make steam water supply does not keep up, pulled hose from discharge filter found little pressure. Had maintenance check for filter on hand. Replaced right hand filter tested found still slow removed left hand filter. Found water flow to greatly increase to normal pressure. Removed filter and tested unit found okay. Maintenance said they will get filter to install.

Near Cree Dr, Lock Haven, PA 17745
Service C.

Service C.

Arrived, spoke to manager, said CHA Dishwasher wash rinse display was not displaying, final rinse displaying temp but when they run their sensor displays different temp, rollers on conveyor some are bad and left hand spray nozzle not working fully on wash table. Checked thermistors for wash and rinse found okay up to display board found 24v to board but not displaying. Will order digital temp display. Ran unit temped final rinse, display showed 186 degrees and thermistor resistance showing about 1070 ohms which matches per resistance chart, believe thermostat short cycling will order and replace. Checked over rollers found multiple rollers damaged but not preventing proper operation, manager said to wait to replace. Checked left hand spray nozzle on wash table found valve partially opening allowing some water but not full flow. Will order solenoid and replace. Will send quote for repairs.

Near Cree Dr, Lock Haven, PA 17745
Service C.

Service C.

Found right hand nozzle not spraying on wash table next to dishwasher. Checked over unit found channel locks clamped on water hose to nozzle, found with water cut in solenoid valve leaking at body and spraying water. Clamped hose to shut water off. Verified correct operation of sensor. Found 24v to valve when sensor is interrupted. Will order solenoid valve and return.

Near Cree Dr, Lock Haven, PA 17745
Service C.

Service C.

Found top Microwave Oven unit off, checked error log found 6 low mag amps. Entered test mode found door switches okay. Found 20 amp fuse blown. Replaced, checked components on microwave circuit found okay. Tested amp draw found 14.9 amps. Let unit heat and ran product, found okay. Unit is operating correctly at this time.

Near Bellefonte Ave, Lock Haven, PA 17745
Service C.

Service C.

checked over Microwave Oven unit, found unit giving F1 error and immediately shutting down, found blower motor only reaching about 50% speed, blower motor is failing and will need to be replaced, also found motor control failing and will need to be replaced. unit is currently not functional. customer ordering parts. 10/20/20 Removed all panels, removed failed BMSC, installed new BMSC, removed failed blower motor, installed new blower motor, reinstalled panels, turned on unit, no errors at startup, put unit into test mode, checked blower motor at all speeds, verified blower motor functions properly, took unit out of test mode, allowed unit to heat, tested operations, confirmed unit working correctly at this time.

Near Bellefonte Ave, Lock Haven, PA 17745
Service C.

Service C.

Replaced microwave oven latch assembly as the old one screw hole were stripped. found screws on truck stock that would work. cut down and installed. had issues aligning latch and catch. got together after finding a spacer in unit. got all to work and tested. found all okay at this time.

Near Bellefonte Ave, Lock Haven, PA 17745
Service C.

Service C.

Removed failed burner valve on Broiler and replaced. Found unit acting same. Cleaned orifice and cleared all gas lines. Checked gas pressure found okay. Believe right side burner is defective and needs replaced. 10/16/19 Removed failed burner assembly and replaced. Unit operating normally at this time.

Near E Main St, Lock Haven, PA 17745
Service C.

Service C.

Found Warming Cabinet unit plugged into burnt GFCI outlet. Customer will replace outlet. Unit needs power switch replaced. 9/19/19 Replaced switched. tested okay.

Near Pine Mountain Rd, Lock Haven, PA 17745
Service C.

Service C.

Found warming cabinet unit plugged into burnt GFCI outlet. Customer will replace outlet. Unit needs power switch replaced. 9-19-19 Replaced switched. tested okay.

Near Pine Mountain Rd, Lock Haven, PA 17745
Service C.

Service C.

Picked up new doors for top and bottom Southbend oven units from maintenance shop to install. Then I removed the faulty doors and seals. I installed the new components and made necessary adjustments so everything worked correctly. I took the old parts back down to maintenance and cleaned up debris.

Near Cree Dr, Lock Haven, PA 17745
Service C.

Service C.

Found both ovens over temping. Tried to calibrate but both kept climbing higher until reaching 100°f over set points. Will need temperature controls replaced. 8/30/19 Replaced both thermostats and checked for leaks. found some redone connections and retested. found no leaks. lit all pilots and tested ovens okay. checked calibrations and made required adjustments. let cycle found all okay at this time.

Near N Henderson St, Lock Haven, PA 17745
Service C.

Service C.

I checked temperature on Reach-In Cooler unit and it was running below freezing. I tried adjusting the start but it was still shutting off below freezing. I spoke to True to find out the stat temp range for the coil. I ran and picked one up and replaced the faulty stat. I rechecked temp and adjusted as needed. The unit is working fine at this time.

Near E Walnut St, Lock Haven, PA 17745
Service C.

Service C.

The Electric Steamer unit wouldn't power up so I opened it up and the power wires were burnt up. I rewired the unit and installed a new contactor. I checked operation and the unit is working fine at this time.

Near Pine Mountain Rd, Lock Haven, PA 17745
Service C.

Service C.

Found unit thermostat calling for heat but drawing no amps on griddle (flat top on range). Will need heating element replaced on far right side. 8-7-18 I lifted the griddle top off and found the right and left elements were bad I only had the one for the right. I pulled the griddle top apart and removed the old element and installed the new one. The unit is in rough shape and a lot of the hardware is stripped out. I had maintenance help me put the griddle back in place. I checked operation and the middle and right side were working fine. We will need to order parts and return to install.

Near Cree Dr, Lock Haven, PA 17745
Service C.

Service C.

Checked pilots on VHL Range, 2nd in from left, found full of debris and will need replaced. Will obtain new and return to replace. 1-8-18 Found unit on customer showed me the issue with rear pilot, and issue with front per customer front needed adjusting and rear needed replaced. Did so, tested found unit worked as before service. Found rear burner flame is real high, checked parts on that burner, all seem to be okay, gas pressure okay @3.8 in. wc. Put pot on top and ran burner, seemed okay. Customer wants price on grates for top included. Below is a price for each grate. Closed up unit, all okay at this time, grate cost each $53.60. **Travel charges billed on wo# 147299**

Near E Bald Eagle St, Lock Haven, PA 17745
Service C.

Service C.

found door for Walk-In Cooler is not sitting in frame straight but it can not be adjusted. Seal still seems to cover frame. Over looked area where ice build up is and found on top right hand corner of door where the door heater ran, the heater was off the track it clips onto causing seal to not close tightly. Fixed and found screws on threshold tearing up the seal on both freezer and cooler doors, Unit needs flush mounted screws and seals. 8/16/17 Checked function of door heaters, they are working. Chipped off more ice that was there from before. Called Jeff and John to give them info on situation. John wants to hear back if we get a hold of Tafco. 8/25/17 found unit with torn door sweeps, removed and replaced. Removed freezer door seal and replaced. Adjusted door hinge spring on freezer, found freezer door heater pulling out of mount when door is opened and not allowing door to close and seal. Drilled heater cover and pop riveted, door sealing okay at this time.

Near W Water St, Lock Haven, PA 17745
Service C.

Service C.

Found open wires due to getting caught in window. Repaired, tried to energize. Had voltage but still not working. Found wires pulled out of power supply to board. Will need new molex plug. 5-3-17 replaced cable. Checked operation, found board not working, window needs new chain assembly to be able to check complete operation, will obtain and return. 5-11-17 installed chain in between drive through customers. Had to stop and start a few times got chain in and unit failed to open and close on its own. Found screws for frame missing. Found a few in my truck that would work. Also had to bend cover to fit frame better. Still was failing sometimes. Pulled sensor bar and found it was very dusty. Cleaned and close-up had customer test found all OK at this time ** Travel Charges billed on WO#132558

Near Bellefonte Ave, Lock Haven, PA 17745
Service C.

Service C.

Found pilots not lighting. Tested pilot valve and had plenty of "wc. Removed pilots and tried cleaning in sink, helped but did not look strong. Blew nitrogen through pilot assembly and got a lot of dirt out. Tested, unit now operating normally.

Near E Bald Eagle St, Lock Haven, PA 17745
Service C.

Service C.

found unit off. Accessed components, performed output test. Found hose out of pumps with holes. Sealed temporarily, ran, found no leaks. Ran clean cycle, found okay. Will obtain new hose and return. Replaced door seal and dropped off 2 buckets of cleaning tabs. 12-2-16 found unit off. Drained water, installed new hose, checked operation, found okay at this time.

Near Slate Run Rd, Lock Haven, PA 17745
Service C.

Service C.

Found water to unit (steamer) was very slow, found no pressure when in use "0 psi" shut down, replaced clogged filter, ran, found 25 psi when in use. Let fill, heat , watched unit to make sure it's okay. Found small leak on right side hose, clamp was loose. Tightened up, all okay at this time.

Near W Water St, Lock Haven, PA 17745

Planned Maintenance

A planned maintenance agreement can keep your equipment running longer than the factory warranty. Reduce cost, downtime and have your equipment running at top performance when you need it most.

We Do It Right The 1st Time!

See what our customers think about our service!

Great service Very courteous polite and knowledgeable The Gardens At Stroud Stroudsburg
Super Guys! The K & D Team of repairman are super!. always courteous, friendly and get the job done right! Answer my questions and never a surprise cost. Dunmore Health Care Center Dunmore
Maintenance Supervisor Shawn is a good Devoted Service Tech from your Altoona Offfice Steve Long is always a great help when i call him Mount Union School District Mount Union
Read More